step load造句
例句与造句
- Neural network model for rheology of rock and soil under step loading
分级加载下岩土流变的神经网络模型 - The step load is a good way to determine the number of users at which this occurs
单步负载是确定发生上述情况时的用户数的好方法。 - Step load change
负荷阶跃 - Dislocation distribution function of the edges of an axially symmetric crack subjected to unit - step loads
轴对称裂纹表面受阶跃载荷的位错分布函数 - Elastic - plastic dynamic response mechanism of a variable cross - section cantilever beam subjected to step load
阶跃载荷作用下变截面悬臂梁的弹塑性响应模式 - It's difficult to find step load in a sentence. 用step load造句挺难的
- The step load pattern is used to specify a user load that increases with time up to a defined maximum user load
单步负载模式单步负载模式用于指定随时间不断增加到定义的最大用户负载的用户负载。 - For example , set the start and maximum user counts for the step load pattern . after you choose the load pattern , click next
选择了负载模式之后，单击“下一步”可前进到“负载测试向导”的“文本组合”页。 - With the stepping load , you also have to monitor agent resources closely to make sure that the agents can generate the desired load
使用单步负载时，还必须密切监视代理资源，以确保代理能够生成所需的负载。 - Under the integral control mode , the same simulation results are got with the difference integral and differential coefficient when the step load happens
在积分控制工作方式下，取不同的积分、微分系数，在负载阶跃变化时得到了与模拟控制相同的仿真波形。 - From the beginning construction of the raft foundation to sealing roof during the overall construction procedure , the representative seven step loads are selected to apply to the simulating models
计算时重点选取了从筏板施工开始至主楼结构封顶的全过程中具有代表性7次荷载进行模拟。 - The advantages and disadvantages of current - mode control technique is analyzed and studied intently . according to these , the small signal model of phase - shifted full - bridge converter in continuous current is built . by using matlab tools , the simulations of response of output voltage due to the step load are given
本文重点分析了电流型控制的优缺点，在此基础上，建立了电流连续时全桥移相zvspwmdc - dc变换器闭环小信号模型，得到了负载阶跃扰动时输出电压的仿真波形。 - Used the metering - out control system in which the hydraulic cylinder was the executive element as research object in this thesis , the experimental research about the effect on the pressure p1 , p2 of the hydraulic cylinder chambers when series - connecting throttle valve or governor valve on the return oil - line under the step load changing have made
本文以单出杆液压缸为执行元件的出口节流调速系统为研究对象，在其回路上分别串接节流阀和调速阀，当负载发生阶跃变化时，对液压缸两腔压力p _ 1 、 p _ 2的影响进行了试验研究。 - Through experimental research , the calculation formula that the pressure highly - adjusted capacity of two cylinder chambers varied with the change of step load and the formula about hydraulic elements main parameter ( rated pressure ) were both made , which had important valuation in selecting the main parameter about this hydraulic system
通过试验研究得出了出口节流调速系统中液压缸两腔压力超调量随负载变化的计算公式以及出口节流调速系统中液压元件主参数(额定压力)计算公式，有利于正确选择系统的元件及主参数。 - When the governing valve was series - connected on the return oil - line in the metering - out control system , under the same flow area and the same adjusted pressure of relief valve , with the incremental quantity of step load , the pressure highly - adjusted capacity of the hydraulic cylinder chamber with piston - rod increased , meanwhile , it ' s time of rise , time to peak and the governing time all increased . at the same time , the pressure highly - adjusted capacity of the hydraulic cylinder chamber without piston - rod increased
当出口节流调速系统的回油路上串接调速阀时，随阶跃负载的增加，在相同流量阀开度、相同溢流阀调节压力的情况下，液压缸有杆腔压力p _ 2 ( t )的超调量是增加的，上升时间、峰值时间以及调整时间也是增加的；液压缸无杆腔压力p _ 1 ( t )的超调量是增加的。 - The result shows that the potential difference between the upper side and bottom side of the cantilever sample present the biphasic pulse when it is under step load , the result also shows the potential between the upper side and bottom side of the four point bending beam adds with the frequency of load , but the phase difference changes opposite from the potential
结果表明流动电位差在跃阶载荷作用下存在双脉冲现象，而在受交变载荷时其值随载荷频率的增加而增加并趋于平缓，其相位差则与电位差的变化刚好相反，这与gross和salzstein等的结果一致。
更多例句： 下一页